Blog

In a few clicks you can upload a master list of these items for the Parts List, Processes and Functional tests. Contact [email protected] to get a sample of these files to modify and use!

Remove columns from the BoC you don’t want such as checked and Belongs to. Click the fourth icon on the BoC on the left, under the funnel, and click to hide items you don’t need [...]

After you create candidates, the tolerances are locked in. If you forgot, no problem. Set the tolerances and then select all ballooned data and right click. Select to apply the tolerances, that are correct for [...]

Load the drawing and click the eye icon to view if the drawing is of good or poor quality. If poor quality, do not run the IDA; instead manually balloon.

To check on the status of Intelligent Drawing Analysis (IDA™) processing on your drawings, click IDA on the menu at the top, then Show IDA Status to view the status.

Faster Manually Ballooning GD&T. No time delays!

No need to press the Shift key when ballooning a note.

Better Ability to Manually Balloon. Switch to Notes for Notes and GD&T for dimensions.

When you load these poorly displayed drawings, choose to not run IDA™ and manually balloon them as you normally would.

After you balloon, press CTRL and W and anything characteristics not in orange blocks per the Intelligent Drawing Analysis (IDA™) that display, you can manually balloon and renumber.

Open the Characteristic Properties and select the dock icon and this page will populate the right side of the DISCUS panel. Un dock to remove this from the right panel